Kit Includes:

C&L Performance Air Induction System
Custom Tuned Diablosport Handheld Tuner
Stant High Performance 180 Thermostat

**NOTE** This Package includes a custom tune for the SRT8. We are still working with Diablo to have the custom tune pre-programmed into the tuner. Tunes will be e-mailed to you while we work with Diablo.

Our new intake consists of an all new CNC machined cast aluminum inlet pipe assembly (with provisions for the IAT sensor, PCV hose connection and a special nitrous boss), a molded filter shroud assembly that attaches to the lower half of the factory air box assembly and a custom washable air filter that was developed specifically for this system. The air filter in this package maximizes the total amount of available area inside of the shroud assembly, and features over 180 square inches of filtration surface area! The original paper filter, which is more restrictive per square inch than our cotton mesh filter, has a total of only 89 square inches of filtration. Although the filter is visible when the hood is open, our rubber trim seal at the top of the filter shroud isolates the filter from the engine compartment heat once the hood is closed. This ensures that all airflow that enters the filter comes from below the body of the vehicle, just like the factory arrangement.

Dyno Results

While developing this system, we noticed that manufacturers of existing HEMI intake upgrades were making "sensational" power claims. One particular manufacturer, who states in their advertising and literature that their intake adds "21 rear wheel horsepower", sells an intake that flows less than 720 CFM. Another manufacturer, who claims to have been producing (up to this time) the "highest flowing" air intake for these vehicles, advertises a system with a maximum flow capacity of 847 CFM. Our new assembly, which is airflow restricted only by the size of the factory throttle body, features a full 4" diameter inlet pipe assembly and flows 935 CFM, even when attached to a stock HEMI throttle body opening. The maximum flow capacity for our system is restricted by the fact that the factory throttle body has an outside diameter of only 3.5". When this restriction is eliminated (simulating a 4" throttle body opening), our new system flows an amazing 1,015 CFM! Click here to see the Air Flow Comparison